DMP Electronics SCS2 Bedienungsanleitung PDF herunterladen (Seite 28)

JTAG-Booster for AMD ÉlanSC520

28 JTAGEL5d.doc

The following options are valid for most functions:

/DRIVER=x with x = 1,2,3,4

A driver for the interface to the JTAG-BOOSTER on the parallel port may be

specified. /DRIVER=1 selects the fastest available driver, /DRIVER=4 selects the

slowest one. Use a slower driver if there are problems with JTAG-BOOSTER.

Default: /DRIVER=3

/INI=file

An initialization file may be specified. By default the current directory is searched

for the file JTAGEL5.INI. If this file is not found and no initialization file is specified

in the command line, default initialization values are used (see also chapter 1.6

“Initialization file JTAGEL5.INI”).

Default: /INI=JTAGEL5.INI

/LATTICE

For demonstration purposes this software works with the Lattice ispLSI-Adapter,

too. With the option /LATTICE you can simulate the speed achievable with the

simple ispLSI-Adapter.

/LPT1 /LPT2 /LPT3

A printer port may be specified where the JTAG-Booster resides.

Default: /LPT1

/LPT-BASE

The physical I/O-Address of printer port may be specified instead of the logical

printer name.

/OUT=file_or_device

All screen outputs are redirected to the specified file or device. Note that you can't

redirect to the same parallel port where the JTAG-Booster resides.

Default: /OUT=CON

/PAUSE

With the option /PAUSE you can force the program to stop after each screen.

Please do not use this option if you redirect the output to a file.

Abbreviation: /P

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 50 51

Keine Kommentare

DMP Electronics SCS2 Bedienungsanleitung Seite 28